To Generate A Host Public Key For Ssh Service - Sun Microsystems Sun SPARC Enterprise M3000 Administration Manual

3. Type the setssh command:
XSCF> setssh -c function
where function is either enable or disable. You must generate a host public key
to use SSH.

▼ To Generate a Host Public Key for SSH Service

1. Log in to the XSCF console with platadm privileges.
2. Type the setssh command:
XSCF> setssh -c genhostkey
For additional options with the setssh command, including information on adding
or deleting user public keys, see the setssh(8) man page or to the SPARC Enterprise
M3000/M4000/M5000/M8000/M9000 Servers XSCF User's Guide.
▼ To Set the Altitude on the Service Processor
1. Log in to the XSCF console with fieldeng privileges.
2. Type the setaltitude command:
XSCF>
where
hundred meters.
3. To verify the operation, type the showaltitude command.
46 SPARC Enterprise Mx000 Servers Administration Guide • August 2009
setaltitude -s altitude=
is a unit of meters. The unit of meters is rounded off to the nearest
value
value