To Configure The Xscf Network Interfaces - Sun Microsystems Sun SPARC Enterprise M3000 Administration Manual

2. Type the showdscp command:
XSCF> showdscp
Command output example for a DSCP network of 10.1.1.0 and a DSCP netmask
of 255.255.255.0 is:
XSCF> showdscp
DSCP Configuration:
Network: 10.1.1.0
Netmask: 255.255.255.0
Location
XSCF
Domain #00
Domain #01
Domain #02
Domain #03
...

▼ To Configure the XSCF Network Interfaces

Settings to configure the XSCF network must be applied to XSCF, and the Service
Processor must be reset, before the settings become effective. See
the XSCF Network" on page
1. Log in to the XSCF console with platadm privileges.
2. Type the setnetwork command:
a. To set the network interface, netmask, and IP address:
XSCF> setnetwork interface [-m addr] address
XSCF> setnetwork xscf#1-lan#0 -m 255.255.255.0 192.168.11.10
32 SPARC Enterprise Mx000 Servers Administration Guide • August 2009
Address
10.1.1.1
10.1.1.2
10.1.1.3
10.1.1.4
10.1.1.5
where interface specifies the network interface to be set, -m addr specifies the
netmask address of the network interface, and address specifies the IP address
of the network interface. If the -m option is omitted, the netmask
corresponding to the IP address is set. See
The following example sets the IP address and netmask for the interface XSCF-
LAN#0 on XSCF Unit 1 in a high-end server:
34.
TABLE 3-1
"To Set Or Reset
for valid interface names.