To Set Or Reset The Xscf Network; To Display Xscf Network Configuration - Sun Microsystems Sun SPARC Enterprise M3000 Administration Manual

▼ To Set Or Reset the XSCF Network

When you set or change the Service Processor host name, DNS domain name, DNS
server, IP address, netmask, or routing information, the settings must be applied to
XSCF, and the Service Processor must be reset, before the settings become effective.
1. Log in to the XSCF console with platadm privileges.
2. Type the applynetwork command:
XSCF> applynetwork
The applynetwork command displays the information that has been set for the
XSCF network, and asks you to apply the settings.
3. Execute the rebootxscf command to make the settings effective:
XSCF> rebootxscf
4. Verify the operation with the shownetwork command.

▼ To Display XSCF Network Configuration

1. Log in to the XSCF console.
2. Type the shownetwork command:
XSCF> shownetwork -a | interface
where -a displays information for all XSCF network interfaces, and interface
displays information for a specific XSCF network interface name, in the format
xscf#x-y.
Command output example for the XSCF Unit #0, LAN#1 is:
XSCF> shownetwork xscf#0-lan#1
Link encap:Ethernet HWaddr 00:00:00:12:34:56
inet addr:192.168.10.11 Bcast:192.168.10.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
...
34 SPARC Enterprise Mx000 Servers Administration Guide • August 2009