To Give A Vacm Group Access To A Vacm View; To Display Vacm Information For The Snmp Agent - Sun Microsystems Sun SPARC Enterprise M3000 Administration Manual

2. Type the setsnmpvacm command:
setsnmpvacm
XSCF>
where OID_subtree
entire MIB tree, and can be limited to certain portions of the tree by using the
optional OID_Mask
agent exported MIB information. View access is read-only for the agent.
3. To verify the operation, type the showsnmpvacm command.

▼ To Give a VACM Group Access to a VACM View

1. Log in to the XSCF console with platadm privileges.
2. Type the setsnmpvacm command:
XSCF> setsnmpvacm
where
viewname
group name.
3. To verify the operation, type the showsnmpvacm command.
▼ To Display VACM Information for the SNMP
Agent
1. Log in to the XSCF console with platadm or platop privileges.
createview -s OID_subtree [-m OID_Mask] viewname
is the MIB OID subtree for the view (values start at .1 for the
), and viewname is the name of the view to create for the SNMP
createaccess -r viewname groupname
is a valid SNMP agent view, and is a valid SNMP agent
groupname
Chapter 3 System Configuration 41