To Enable The Snmp Agent; To Display Snmp Agent Configuration - Sun Microsystems Sun SPARC Enterprise M3000 Administration Manual

encryption_password is the encryption password, trap_port is the listening port for
the SNMP agent (the default is 161), and traphost is the host name where the
SNMP manager application is running.
If you do not specify the passwords, you are prompted to enter them.
3. To verify the operation, type the showsnmp command.
For additional options with the setsnmp command, including information on
configuring your system to accept SNMP version 1 or 2 traps, see the setsnmp(8)
man page.

▼ To Enable the SNMP Agent

1. Log in to the XSCF console with platadm privileges.
2. Type the setsnmp command:
XSCF> setsnmp enable
3. To verify the operation, type the showsnmp command.
Make sure that your SNMP manager application can communicate with the Service
Processor SNMP agent based on the configuration you used for the agent, namely,
user, port, and trap information.

▼ To Display SNMP Agent Configuration

1. Log in to the XSCF console with platadm or platop privileges.
Chapter 3 System Configuration 43