Kohler Command Pro CV960 Service Manual page 91

Remove Lifter Feed Chamber Cover and
Gaskets
chamber cover, and gaskets. Carefully separate
Cover
Figure 8-60. Removing Lifter Feed Chamber Cover
Components.
Remove Flywheel and PTO End Oil Seals
1. Remove the oil seals from the crankcase and oil
Figure 8-61. Removing Oil Seals.
Screws
Gasket
Removal of Main Bearings
should only be removed if replacement
is required due to wear. If removal is
performed, use a press and support the
adjacent cast surface around the bearing
Support
This Surface
Figure 8-62. Support Surface Details.
Section 8
Disassembly
Do not press
8
8.15