Kohler Command Pro CV960 Service Manual page 55

Kill Switch or
''Off'' Position of
Key Switch
Figure 7-4. Capacitive Discharge Fixed Timing Ignition System.
dead center.
L1
Figure 7-5. Capacitive Discharge (CD) Ignition Module Schematic.
Troubleshooting CD Ignition Systems
information is provided to help you get to the root of
CAUTION: High-Energy Electric Spark!
wires are connected, including the spark plug leads.
sure the ignition switch is in the run position.
Electrical System and Components
(0.28/0.33 mm)
0.011/0.013 in. Air Gap
D1
C1
SCS
L2
Test Procedure for Standard (Fixed Timing) CD
Ignition System
ignition system.
Ignition
Modules
Magnet
Flywheel
T1
P
S
excessive load on the kill lead. If a customer
complains of hard starting, low power,
excessive draw on the kill circuit. Perform the
appropriate test procedure.
harnesses from the engine and equipment are
the connectors and position or insulate the kill
lead terminal so it cannot touch ground. Try to
start the engine to verify whether the reported
testing, you may need to ground the kill lead
to shut it down. Because you have interrupted
the kill circuit, it may not stop using the
switch.
Section 7
Spark Plug
Spark Plug
7.5
7