Kohler Command Pro CV960 Service Manual page 89

Figure 8-52. Removing Oil Pan.
Oil Pump Assembly
The oil pump is mounted to the inside of the oil pan.
If service is required, refer to the service procedures
Remove Camshaft
Figure 8-53. Removing Camshaft.
Remove Connecting Rods with Pistons
and Rings
closest connecting rod end cap. Remove the end
Figure 8-54. Removing Connecting Rod Screws.
NOTE: If a carbon ridge is present at the top
of either cylinder bore, use a ridge
reamer tool to remove the ridge before
Figure 8-55 Remove Connecting Rod Caps.
NOTE: The cylinders are numbered on the
crankcase. Use the numbers to mark
each end cap, connecting rod and piston
for reassembly. Do not mix end caps and
connecting rods.
Section 8
Disassembly
8
8.13