Kohler Command Pro CV960 Service Manual page 72

Section 7
Electrical System and Components
Figure 7-39. Installing Thrust Washer.
drive end cap, and install the armature with the
drive pinion.
captured washer and the rear of the pinion.
at the same time seat the drive lever into the
housing.
Figure 7-40. Installing Armature and Pivot Lever.
7.22
Thrust Washer
Figure 7-41. Installing Backup Washer and
Grommet.
Figure 7-42. Installing Frame and Drain Tube.
grommet, into the matching recess of the drive
end cap. The molded recesses in the grommet
notch with the corresponding section in the