Kohler Command Pro CV960 Service Manual page 86

Section 8
Disassembly
Remove Valve Covers
1. Remove the screw and grommet securing each
valve cover.
2. Remove the valve cover and gasket from each
cylinder head. Note the locations of individual
Figure 8-38. Removing Valve Covers.
Remove Cylinder Heads and Hydraulic
Lifters
rocker arm adjusting nuts.
2. Remove the pipe plug from the cylinder head to
access the screw in the center location. See Figure
Figure 8-39. Removing Pipe Plug.
cylinder head. Note the locations of washers and
8.10
Figure 8-40. Removing Cylinder Head Fasteners.
3. Mark the position of the push rods as either
rods should always be reinstalled in the same
positions.
4. Carefully remove the push rods, cylinder head,
5. Repeat the procedure for the other cylinder head.
Pipe Plug
Figure 8-41. Removing Cylinder Head Assembly.
either intake or exhaust and cylinder 1 or 2.
of the engine. The cylinder head number
is embossed on the outside of each
Spacer
Washers