Kohler Command Pro CV960 Service Manual page 38

Section 5
Fuel System and Governor
Fuel Bowl
Bowl Drain Screw
Figure 5-18. Fuel Bowl Removed From Carburetor.
is not necessary unless the Fuel
Solenoid Kit, or Fuel Bowl Kit (obtained
separately), will also be installed.
Discard all the old parts. The seat for the inlet
needle is not serviceable, and should not be
removed.
Float
Inlet
Needle
Figure 5-19. Removing Float and Inlet Needle.
carefully remove the two main jets from the
carburetor. Note and mark the jets by location for
of the nozzles. The end with the two raised
main jets. Save the parts for cleaning and reuse.
5.10
Main Nozzles
Main Jets
Figure 5-20. Main Jets and Nozzles Removed.
ground lead (if equipped), from the top of the
mark or tag for proper reassembly. Note the small
a Jet Kit is also being installed. Clean the slow
jets using compressed air. Do not use wire or
carburetor cleaner.
Figure 5-21. Removing Screw and Washer.
Slow (Idle Fuel) Jets
Figure 5-22. Slow Jets and O-Ring Detail.
O-Ring