Kohler Command Pro CV960 Service Manual page 36

Section 5
Fuel System and Governor
Move and Hold
Lever in "Full
Throttle" Position
Figure 5-11. Setting High Speed RPM (Air Cleaner
Removed for Clarity).
Carburetor Servicing
The following section covers the disassembly,
various servicing procedures and reassembly of the
carburetor. For each procedure carefully inspect
all components and replace those that are worn or
damaged. The following should also be noted as
• Inspect the carburetor body for cracks, holes, and
other wear or damage.
• Inspect the fuel inlet needle and seat for wear or
damage.
• The choke plate is spring loaded. Check to make
Fixed jets for high altitudes are available.
Float Replacement
If symptoms described in the carburetor
1. Perform the removal procedures for the
appropriate air cleaner and the carburetor
material before disassembling the carburetor.
Remove the four mounting screws and carefully
5.8
High Speed (RPM)
Adjustment Screw
separate the fuel bowl from the carburetor. Do
any remaining fuel into an approved container.
Save all parts. Fuel can also be drained prior to
Fuel Bowl
Bowl Drain Screw
Figure 5-12. Fuel Bowl Removed From Carburetor.
Discard all of the parts. The seat for the inlet
needle is not serviceable, and should not be
removed.
Float
Inlet
Needle
Figure 5-13. Removing Float and Inlet Needle.
4. Clean the carburetor bowl and inlet seat areas as
required, before installing the new parts.
should point up, with the needle valve hanging