Kohler Command Pro CV960 Service Manual page 88

Section 8
Disassembly
Valve Stem Seals
Figure 8-47. Valve Stem Seals.
NOTE: These engines use valve stem seals on
the intake and exhaust valves. Use a
new seal whenever valves are removed,
or if the seal is deteriorated in any way.
Never reuse an old seal.
4. Repeat the above procedure for the other cylinder
head. Do not interchange parts from one cylinder
head to the other.
Remove Breather Assembly
breather assembly, and gasket to the crankcase.
2. Carefully break the gasket seal and remove the
surfaces as it could cause damage resulting in
leaks. Note the assembly and orientation of parts.
Figure 8-48. Removing Breather Assembly.
8.12
Filter
Figure 8-49. Removing Breather Filter.
Remove Oil Pan Assembly
Figure 8-50. Removing Oil Pan Screws.
2. Locate the two protruding tabs on the oil pan.
Carefully tap to break the gasket seal. Do not pry
Breather
on the sealing surfaces as this could cause leaks.
Separate the oil pan from the crankcase. See
Gasket
Figure 8-51. Location of Protruding Tabs.
Tabs