Kohler Command Pro CV960 Service Manual page 90

Section 8
Disassembly
2. Carefully remove the connecting rod and piston
Figure 8-56. Removing Piston/Connecting Rod
Assemblies.
3. Repeat the above procedures for the other
connecting rod and piston assembly.
Remove Crankshaft
used.
Figure 8-57. Removing Crankshaft.
Removal of Governor Gear Assembly
molded tabs in the gear. When the gear is removed
must be replaced. Therefore, remove the gear only
yoke, or gear condition does not require removal,
necessary, perform as follows:
8.14
1. Remove the locking tab thrust washer and note
orientation.
2. Using a screwdriver, carefully pry up to unseat
governor gear assembly from the governor gear
Figure 8-58. Removing Governor Gear.
needed.
Remove Governor Yoke, Cross Shaft, and
Oil Seal
1. Remove the two mounting screws securing the
Figure 8-59. Removing Cross Shaft/Yoke Screws.
remove seal.
Governor Gear