Kohler Command Pro CV960 Service Manual page 41

lever from the carburetor housing. Save the
bushing to use as a driver for installing the new
bushing. Discard the old lever.
required.
7. Insert the new bushing through the new choke
lever from the outside, and start the bushing in
the protruding boss on the carburetor housing is
between the two stops formed in the choke lever.
Figure 5-30. Assembling Choke Lever.
8. Turn the old bushing upside down and use it
as a driver to carefully press or tap the new
Check that the choke lever pivots freely without
Figure 5-31. Installing Bushing.
Stops
Boss
Fuel System and Governor
9. Install the new return spring onto the new choke
the following step.
Choke Shaft
Figure 5-32. Choke Shaft and Spring Details.
counterclockwise with the inner leg of the spring,
against the formed stop within the choke lever as
The outer leg of the spring must still be behind
Figure 5-33. Installing Choke Assembly
Components.
11. Place a drop of Loctite
new screw. Position and install the new choke
two screws. Close the choke and check the plate
alignment within the carburetor throat, then
tighten the screws securely. Do not overtighten.
Section 5
Spring Ends
® on the threads of each
5.13
5