Kohler Command Pro CV960 Service Manual page 40

Section 5
Fuel System and Governor
Retaining
Screw
Pivot
Pin
Figure 5-26. Installing Float Assembly.
hangs vertically and rests lightly against the
fuel inlet needle. The inlet needle should be
fully seated but the center pin of the needle (on
retainer clip end) should not be depressed. Check
the fuel inlet needle without depressing
the center pin.
in.) ± 1.5 mm (0.059 in.)
surface, not the rubber gasket, if still
Figure 5-27. Checking Float Height.
5.12
Figure 5-28. Installing Fuel Bowl.
Choke Repair
1. Remove the carburetor from the engine. Discard
17 mm (0.669
3. Remove and discard the plastic cap from the end
4. Note the position of the spring legs and the choke
Figure 5-29. Choke Details.
carefully reinstall the fuel bowl, using new
original screws. Torque the screws to
2.5 ± 0.3 N·m (23 ± 2.6 in. lb.)
the old mounting gaskets for the air cleaner and
carburetor.
self-relieving choke mechanism thoroughly.
plate for correct reassembly later. See Figure
carburetor body, note the preload of spring and
discard the removed parts.