Section 8
Disassembly
2. Remove the four screws securing each of the
Mounting
Screw Locations
intake manifold to the cylinder heads. Cut any
wire ties securing wiring.
4. Remove the intake manifold and gaskets. See
Mounting
Locations
Figure 8-21. Removing Intake Manifold.
8.6
Remove Oil Cooler
1. Remove the two oil cooler mounting screws. Do
Valley
Figure 8-22. Removing Oil Cooler Mounting
Screws.
2. Loosen the clamps and disconnect each of the
NOTE: New clamps are recommended any time
Mounting
Figure 8-23. Disconnecting Hoses From Oil Cooler.
Locations
Remove Oil Filter Housing
disassembly is performed, or if clamps
have been loosened (expanded) several
times.
housing assembly is not necessary
unless being serviced individually.
Follow Substeps a, b, and c.