Kohler Command Pro CV960 Service Manual page 85

2. Remove the mounting screws securing the
assembly. Note the location of the ground lead.
it may remain mounted to the backing shroud
3. Remove the two screws securing the stator to the
crankcase and carefully separate the stator wires
Mounting
Screws
Figure 8-34. Removing Stator.
4. Unhook the wiring harness from the molded
Ground
Lead
Regulator
Figure 8-35. Removng Wiring Harness.
Remove Backing Shroud Assembly
Plug
1. Remove the four screws securing the backing
Backing Shroud
Assembly
Molded
Clips
Screws
Figure 8-36. Removing Backing Shroud Mounting
Screws.
Remove Spark Plugs
1. Remove the spark plug from each cylinder head.
Figure 8-37. Removing Spark Plugs.
Wiring
Harness
Molded
Clips
shroud assembly to the crankcase. See Figure
Section 8
Disassembly
8
8.9