Kohler Command Pro CV960 Service Manual page 74

Section 7
Electrical System and Components
Extension.
end housing, and carefully place the tool
lead grommet in the cutout of the frame. See
Figure 7-47. Installing Brush Holder Assembly
using Tool with Extension.
the corresponding slot in the grommet of the
holder mounting screws to 2.5-3.3 N·m
Figure 7-48. Torquing Thru Bolts.
7.24
Figure 7-49. Torquing Brush Holder Screws.
the drive lever, and install the spring into the
solenoid. Insert the three mounting screws
through the holes in the drive end cap. Use these
to hold the solenoid gasket in position, then
mount the solenoid. Torque the screws to
to the solenoid and secure with the hex nut.
Torque the nut to
Positive
Brush
Lead
Figure 7-50. Positive (+) Brush Lead Connection.
.