Water Pump Impeller - Gilera GP 800 i.e. Service Station Manual

GP 800 i.e.
Engine
Keep the tie rod in position and screw the nut up
to the end of stroke.
The tool will drive the fixed part seat on the crank-
case and the movable part seat on the shaft, thus
obtaining the correct ceramic seal preloading.
- Screw the rotor. (anticlockwise thread).
Locking torques (N*m)
Water pump impeller 4 ÷ 5
- Fit the pump cover with a new gasket, lubricate
the gasket previously with petroleum jelly grease.
- Tighten the six cover screws to the prescribed
torque.
N.B.
TO AVOID DEFORMATION, DO NOT LUBRI-
CATE THE O-RING WITH PETROLEUM
GREASE.
Locking torques (N*m)
Water pump rotor cover 3 ÷ 4
ENG - 103