Gilera GP 800 i.e. Service Station Manual page 276

Injection
ENGINE RPM SENSOR CONNECTOR
1. Control unit (White)
2. Control unit (Red)
3. Sensor shield (Black)
REVOLUTION TIMING SENSOR
Resistance between "+ and -" = 890 ± Ohm (pins 35 - 25 , engine-side wiring)
Insulation between "+ and S" and between "- and S" (pins 35 - 34 and 25 - 34, engine-side wiring)
Check the continuity between pin 1 of the revolution timing sensor connector and pin 25 of the engine
connector control unit. Check the continuity between pin 2 of the revolution timing sensor connector
and pin 35 of the engine connector control unit. Check insulation between them and the ground lead of
pin 1 and 2 of the connector and shielding. Check the continuity between pin 3 of the connector and
pin 34 of the engine connector control unit.
INJEC - 22
GP 800 i.e.