Pinion Unit Fitting - Gilera GP 800 i.e. Service Station Manual

GP 800 i.e.

PINION UNIT FITTING

- Fit the complete pinion unit in its housing on the
engine.
- Fit the oil sealing cap over the pinion unit shaft.
- Tighten the clamp to the prescribed torque.
Locking torques (N*m)
Oil sealing casing clamp 3 ÷ 5
- Tighten the three fixing screws to the prescribed
torque.
Locking torques (N*m)
Screws fixing pinion unit - chassis 50
- Tighten the oil drain screw «B» to the prescribed torque.
Locking torques (N*m)
Pinion unit oil drain screw 13 ÷ 15
- Undo the oil filling screw «D».
- Fill up to the oil level with the recommended product following the indications described in the figure.
WARNING
DO NOT EXCEED THE "MAX" LEVEL WHEN TOPPING UP.
Recommended products
AGIP ROTRA MP 80W-90 Transmission oil
SAE 80W-90, API GL-5
Engine
ENG - 27