Operating The Projector; Operating The Projector; Switching The Projector On; Selecting An Input Signal - Digital Projection E-Vision 6000 Series User Manual

Digital Projection
E-Vision 6000 Series

Operating The Projector

Switching the projector on

1. Connect the power cable between the mains supply and the projector. Switch on at the switch next to the power connector.
The Power indicator on the projector control panel will show amber and the Warning indicator will show green. The lamp will be off and
the projector will be in STANDBY mode.
2. Press the button on the control panel or on the remote control. The Power indicator on the control panel will flash green for a few
POWER
seconds whilst the lamp comes up to full brightness. When the projector is ready for use, the Power indicator will show steady green.
3. Select the default language.

Selecting an input signal

Connect an input source to the projector. The signal should be automatically detected by the projector, and should be displayed within two or
three seconds.
If more than one signal is connected, then select the input you want to display:
1. On either the control panel or remote, press
2. From the list of available menus, select
3. Use the and arrow buttons to navigate, then
UP DOWN
Rev D July 2014

OPERATING THE PROJECTOR

.
MENU
INPUT .
to select the input you wish to display. Press
ENTER
Installation and Quick-Start Guide
The language selection screen only
appears the first time you power on
the projector. For information about
changing the default language at
a later stage, see the Operating
Guide.
For full details of how to connect an
input source to the projector, see the
Connection Guide.
For full details of how to use the
to exit.
MENU
controls and the menu system, see
the Operating Guide.
Notes
12