Adjusting The Image; Orientation; Aspect Ratio; Picture - Digital Projection E-Vision 6000 Series User Manual

Digital Projection
E-Vision 6000 Series

Adjusting the image

Orientation

1. Press and from the list of options that appears on the screen, select
MENU
2. On the tab, open the
INSTALLATION
Ceiling Rear , Desktop Rear and

Aspect Ratio

1. Press MENU and from the list of options that appears on the screen, select
2. On the IMAGE OPTIONS tab, open the
, and .)
Letterbox True Normal

Picture

1. Press and from the list of options that appears on the screen, select
MENU
2. On the IMAGE tab, access various picture settings, such as

Switching the projector off

1. Press on the control panel or
intention to switch off.
The lamp will switch off, and the Power indicator on the control panel will flash amber for a few seconds whilst the lamp cools. The Power
indicator on the control panel will then show amber and the Warning indicator will show green. The projector will be in Standby mode.
2. Switch off at the switch next to the power connector. Disconnect the power cable from the projector.
Rev D July 2014
setting, then select the desired image orientation. (Choose from
CEILING & REAR
Ceiling Front .)
SCREEN setting, then select the desired screen aspect ratio. (Choose from
Brightness
STANDBY on the remote control, then press the button a second time within 5 seconds to confirm your
OPERATING THE PROJECTOR
.
SETTING
ADJUST .
.
ADJUST
and Contrast .
Installation and Quick-Start Guide
,
Desktop Front
4:3 , 16:9 , 16:10 ,
Always allow the lamp to cool for
5 minutes before:
- disconnecting the power
- moving the projector
Notes
14