Option Tab - Digital Projection E-Vision 6000 Series User Manual

Digital Projection
E-Vision 6000 Series
Setting menu continued...

Option tab

•
Power management
Set the amount of time the projector will remain on without an input
source before going into standby mode.
•
Screen trigger
Set this to to enable the screen trigger.
On
•
Fan control
Max increases the fan speed to compensate for reduced air density at
high altitude.
•
Default input select
If Default input select is set to
Auto
until a source is detected. If set to
used.
•
Color system
Choose the color system for Video and S-Video. Select from
NTSC , PAL and SECAM .
•
Message
If you do not want projector status messages to be displayed, set
Message to .
Off
•
Filter warning
Choose a Filter warning time interval from the list, or select
•
Search mode
Rev D July 2014
, the projector will cycle the inputs
Last , the default input will be the last
Auto ,
Off .
A TOUR OF THE MENUS
Setting
Basic Installation
Power management Off
Screen trigger Off
Fan control Max
Default input select Last
Color system
Video Auto
S-Video Auto
Message Off
Filter warning Off
Search mode Fine
Option
Option
Setting menu

Option tab

Operating Guide
Notes
45