3.2. Controls On E-P Onetouch; Control Functions During Normal Operation; Formula Selection Buttons - Milnor MWR09E5 Series General Operating And Troubleshooting

Chapter 3. Operating
BICEUF01 (Published) Book specs- Dates: 20060823 / 20060823 / 20060823 Lang: ENG01 Applic: CEP

3.2. Controls on E-P OneTouch

Most of the controls on Milnor
Other controls include a mechanical push-button to unlock the door latch, and two lights to
indicate that the machine is running and when the machine is nearing the end of a formula.
Figure 8: E-P OneTouch
.

Control Functions During Normal Operation

3.2.1.

Formula Selection Buttons

3.2.1.1.
programmed formulas that vary according to machine configuration. Start the desired formula by
pressing the corresponding Formula Selection button (
and the door closed.
Consult with your chemical supplier for the specific formula to use with each type of goods being
processed.
Terminate Button
3.2.1.2.
is ended early, you must restart it from the beginning by pressing one of the the Formula
Selection buttons with the door closed.
Last Rinse Light
3.2.1.3.
remains on until the formula ends. If the operator needs to add a chemical during the last bath,
such as softener, he should add it as soon as this light comes on. The Last Rinse light also alerts
the operator that the machine will soon be ready for unloading.
If an error occurs during a formula, this light and the In Progress light flash (two seconds on, then
two seconds off) for 10 minutes. After 10 minutes, both lights go off. The error can be a
malfunction of either the door lock circuit or the inverter. In either case, all machine controls are
locked out for 75 seconds to ensure that the cylinder has coasted to a stop. To open the door after
an error occurs, press the Terminate button (
Unlock button (
In Progress Light
3.2.1.4.
seconds to indicate that the power-up delay timer is counting down. The light goes off when the
power-up delay expires.
This light is constantly on when a formula starts (the door is closed and a formula selection
button is pressed). It remains on until the formula ends normally, is terminated by the operator, or
an error occurs.
PELLERIN MILNOR CORPORATION
®
E-P OneTouch
®
Controls
Control Panel
—The E-P OneTouch
—The Terminate button (
—This light comes on when the last bath step of any formula begins and
) and turn the door latch handle.
'
—When power is first applied to the machine, this light flashes for 75
®
Model Washer-extractors
®
washer-extractors are membrane push-buttons.
®
controller provides four pre-
, ,
" < >
) ends any running formula. When a formula
z
) to clear the error condition, then hold the Door
z
Legend
A. Formula Selection buttons
B. Terminate button
C. Last Rinse light
D. In Progress light
E. Door Unlock button
, or ) with the machine loaded
?