Configuring E-P Onetouch; Is This Switch Position On Or Off - Milnor MWR09E5 Series General Operating And Troubleshooting

Chapter 2. Configuring
Chapter
Configuring
BICEUC01 (Published) Book specs- Dates: 20060823 / 20060823 / 20060823 Lang: ENG01 Applic: CEP

2.1. Configuring E-P OneTouch

The controller must be configured for your specific machine. Configuration information is
controlled by a group of small switches (together called a DIP switch) on the
When power is first applied to the machine, the microprocessor reads the on or off status of each
switch.

Is this switch position ON or OFF?

2.1.1.
You can set any DIP switch position to on or off. To turn a position off, you must either press
down on the side of the switch nearest the word "OFF," or slide the handle toward the position
number. To turn a position "on," you either press down on the side of the switch nearest the
number, or slide the white handle toward the word "ON." Use a pencil or a stiff wire to set the
switch, which will click into either position. See Figure 6 or Figure 7 for the DIP switch location.
Some switch positions are not used on machines equipped with controller board 08BT168AT.
Tip:
See Notice 1 in Section i.1.
PELLERIN MILNOR CORPORATION
2
®
Washer-extractor Models
.
processor board