Formulas In Milnor - Milnor MWR09E5 Series General Operating And Troubleshooting

Figure 5: Timer Stop Connections
Inside of Rear Console (T_E shown, others similar)
.
BICEUP02 (Published) Book specs- Dates: 20060823 / 20060823 / 20060823 Lang: ENG01 Applic: CEP

1.5. Formulas in Milnor

Controls
This section describes the formulas provided in your washer-extractor with the Milnor
electronic timer controller. For each configuration, the table shows each step in the four available
formulas.
Two different software chips are available for machines using controller board 08BT168AT:
WUMWR1A for hotels and hospitality installations, and WUMWR1B for healthcare
installations. Your machine was shipped from the Milnor
when the machine was ordered. Contact the factory to purchase the chip necessary to change the
machine from one industry to another.
For machines using controller board 08BT168BT, all formulas are stored in the supplied
controller board, but only one set is available to the user. The available set is determined by the
machine configuration (see Section 2.1.3.2 "Position 2: Use Bed and Bath Linen formulas?").
Note 4: Because plant water pressure influences the time required for the machine to fill, the run times
stated in the tables below do not include machine fill times.
Note 5: Drain and coast times are subject to change without notice.
Note 6: Certain chemical supply systems may actuate an input to the microprocessor which stops the
formula timer. This action increases the total time required for the formula to complete, but does not affect
the elapsed time.
— End of BICEUI01 —
®
Washer-extractors with E-P OneTouch
Chapter 1. Commissioning
A. Timer stop connections
B. Processor board
C. Inverter
®
factory with the chip set specified
PELLERIN MILNOR CORPORATION
Legend
®
®