Position 1: Configure For Hospitality; Position 2: Use Bed And Bath Linen Formulas - Milnor MWR09E5 Series General Operating And Troubleshooting

Table 8: Controller 08BT168BT: Summary of Configuration Decisions
Switch
Number
1
2
3
4, 5
6
7
8

Position 1: Configure for hospitality?

2.1.3.1.
machine uses formulas designed for the hospitality industry or formulas designed for healthcare
facilities. Set this position on to choose from the available hospitality formula sets. Set this
switch off to choose from the healthcare formula sets. The available formulas in each set are
listed in Section 1.5. "Formulas in Milnor

Position 2: Use Bed and Bath Linen formulas?

2.1.3.2.
the formula set used. Set this switch positon on to configure the machine for bed and bath linen
formulas. Set this switch off to use the kitchen/dining and personal goods formulas. Formulas for
each configuration are listed in Section 1.5. "Formulas in Milnor
®
OneTouch Controls".
An authorized technician can set the machine to diagnostic mode (see Section 2.1.3.7 "Position
8: Set machine to normal operating mode?") to allow manual operation for troubleshooting
(position 8 off and position 2 on).
CAUTION 10 : Entangle and Crush Hazards—Contact with moving components
normally isolated by guards, covers, and panels, can entangle and crush your limbs. These
components move automatically.
• Verify that switch position 2 is on before changing switch position 8 to allow
troubleshooting.
On/Off
Position
Off Healthcare
On Hospitality
Off Kitchen/dining and personal goods
On Bed and bath linens
Note: Always set switch 2 On before changing switch 8 to begin
troubleshooting.
Off Split water for final rinse step
On Cold water for final rinse step
Off, Off Hot bath temperature is 150°F (65.5°C)
On, Off Hot bath temperature is 160°F (71.1°C)
Off, On Hot bath temperature is 170°F (76.7°C)
On, On Hot bath temperature is 180°F (82.2°C)
Off Split bath temperature is 120°F (48.9°C)
On Split bath temperature is 140°F (60°C)
Off Hold step timer until temperature is achieved.
On Run step timer while heating to desired temperature.
Off Machine in diagnostic/troubleshooting mode
Note: Verify that switch 2 is Off before changing switch 8 to begin
troubleshooting.
On Machine in normal operating mode
®
Description
—Switch position 1 determines whether the
Washer-extractors with E-P OneTouch
—DIP switch position 2 determines
®
Washer-extractors with E-P
Chapter 2. Configuring
®
Controls".
PELLERIN MILNOR CORPORATION