Displays In Run Mode - Milnor MWR09E5 Series General Operating And Troubleshooting

Chapter 4. Testing and Troubleshooting
Figure 9: Processor Boards
A. DIP switch
B. Output relays
C. Snubbers
D. Outputs connectors
E. Analog-to-digital connector
F. Power connector
G. Inputs connector
H. Communication connector
I. Pull-down resistor for JTAG port
J. JTAG connector
K. Voltage regulator (5V)
.

Displays in Run Mode

4.2.2.2.
select from five display modes without changing the DIP switch settings: timer, DIP switches,
inputs, outputs, and analog-to-digital channels. The timer display shows certain general
information about the current formula, as explained in Section 4.2.2.2.1. The DIP switches
display shows the on/off status of each DIP switch position. The inputs display (Section
4.2.2.2.3) shows the on/off status of each of the eight inputs. The outputs display, described in
Section 4.2.2.2.4, shows the on/off status of the 16 outputs. The analog-to-digital channel display
is detailed in Section 4.2.2.2.5.
PELLERIN MILNOR CORPORATION
Illustration
Legend
—With the display connected and power to the machine, you can