Commissioning - Milnor MWR09E5 Series General Operating And Troubleshooting

Preface
BICEUK01 (Published) Book specs- Dates: 20060823 / 20060823 / 20060823 Lang: ENG01 Applic: CEP
i. About This Manual
Scope
i. 1.
This manual provides commissioning, operating, and troubleshooting instructions for washer-
extractors in the Milnor
®
OneTouch control. See the installation manual for information on machine installation
procedures and mechanical requirements. See the service manual for preventive maintenance,
service procedures, and mechanical parts identification. See the schematic manual for electrical
parts identification and electrical troubleshooting instructions.
Notice 1 : Milnor MWR_ models sold in North and South America employ the controller
board with Milnor part number 08BT168AT. Similar models sold in Asia may employ controller
board 08BT168AT or the controller board with Milnor part number 08BT168BT. Some minor
differences are determined by the market for which any particular machine is manufactured, but
operation and most troubleshooting procedures are the same. When necessary for clarity in this
manual, specific differences will be identified by the controller board part number.
How to Identify this Manual and its Included Documents
i. 2.
BIUUUD13]
A complete identification of this manual or any document in this manual must include all
specifications shown on the front cover, as defined below:
Published manual number—Primary identification number for the manual or any variation of it.
Specified date—The approximate date of introduction of the product or product change this
manual covers.
As-of date—When a manual for an old product is generated, any new information about the old
product developed up to this date will be included in the manual.
Access date—The date the manual was generated (assembled and formatted).
Applicability—Code(s) that represent a group of machines this manual applies to and/or actual
model numbers of applicable machines. The complete list of applicable models is provided
inside the front cover. If "not used" appears here, this is not a product manual, but has another
purpose such as to provide administrative procedures.
Language Code—A code representing the specific language and dialect of this manual. "Eng01"
identifies the language/dialect of the manual as United States English.
When referring to any document used in this manual (as identified by an eight-character
document number such as BIUUUD13 at the start of the document), a complete identification of
the document must include all specifications shown on the front cover, except substituting the
document number for the published manual number.
®
MWR_ line. These machines are equipped with the Milnor
Preface
®
E-P
[Document
PELLERIN MILNOR CORPORATION