ROBBE-Futaba FX-32 Instruction Manual page 74

Trim setting
Use the touch sensor to move the cursor to
the "TRIM" item of the channel you want to
change and touch the RTN button.
*The trim setup screen is displayed.
The following items can be set at the trim
setup screen:
*The setting can be changed for each condition.
After the set mode is changed from group mode [G] to
single mode [S] at the control selection screen, only that
condition setting is changed by control change; setting of
other conditions remains the same.
Trim selection
Use the touch sensor to move the cursor
to the trim, lever, etc. you want to set and
touch the RTN button.
*The setting can be changed.
Trim rate setting
Use the touch sensor to move the cursor to
the [RATE] item and touch the RTN button to
switch to the data input mode.
Set the trim rate by turning the touch sensor.
Initial value: +30%
Adjustment range : 0~150%
(When the RTN button is touched for 1 second, the trim rate
is reset to the initial value.)
Touch the RTN button to end adjustment and
return to the cursol move mode.
Trim mode selection
Use the touch sensor to move the cursor to
the [TRIM MODE] item and select the trim
mode by turning the touch sensor.
[NORM]: Normal mode. Normal trim (parallel
shift trim) operation.
[ A T L ] : A T L o p e r a t i o n m o d e . M a x i m u m
change near center by operation normally
used with throttle trim. Reverse is also
possible.
[NORM]/[REV] selection is possible at the "ATL
REV" item.
[CENTER]: Maximum change near center by
center trim operation.
74 <Functions of Linkage Menu>
WARNING
As a safety precaution to prevent the motor from
starting unexpectedly, please switch off the
motor accordingly. We also suggest removing
the propeller from the motor as an additional
precaution.