ROBBE-Futaba FX-32 Instruction Manual page 152

Setting method
● Group/Single item: When you also want to
input the same setting contents at other
conditions, perform setting in the group
mode. In this case, the same contents are
input to the other conditions set in the group
mode. When you want to set each condition
independently, select the single mode
(initial setting). Other conditions can be set
independently.
Curve setting examples
The screens shown below are curves created
by entering the pitch rate at low, center, and high
side (3 points or 5 points) at each condition. When
actually creating a curve, input the rate specified at
the fuselage (or the reference value).
●Pitch Curve (Example)
Normal Curve
Pitch Trim (Hovering pitch, high pitch, low pitch)
The hovering pitch, low pitch, and high pitch trim setup screen can be called from the PIT curve setup
screen.
● Hovering pitch
trim setting
● Low/high pitch
trim setting
152 <Functions of Model Menu (Helicopter Functions)>
● Pit trim copy (Hover/high/low)
The pitch trim operating position can be
Move the cursor to the [COPY] item and
After copying, return the pitch trim to the
*For a description of the curve setting method, see the
Idle-up 1 Curve Idle-up 2 Curve
copied to the pitch curve.
touch the RTN button.
center to call the last operating position.
description at the back of this manual.
Hold Curve
(Continued on next page)