ROBBE-Futaba FX-32 Instruction Manual page 66

Model deletion
*The model stored in the transmitter memory or a SD card
can be deleted.
*The current model can not be deleted.
1. Use the touch sensor to move the cursor to
the save destination display ("INTERNAL" or
"MEM. CARD") and touch the RTN button to
switch to the data input mode.
Select the save destination by turning the
touch sensor to the left or right and touch the
RTN button.
[INTERNAL]: Transmitter memory
[MEM. CARD]: SD card
2. Use the touch sensor to move the cursor to
the model you want to delete in the model
list and then touch the RTN button.
3. Move the cursor to [DELETE].
4. Touch the RTN button. When a confirmation
message is displayed and the RTN button is
touched again, the model is deleted.
Model name change
*The current model's name can be changed.
1.Use the touch sensor to select the current
model in the model list and then touch the
RTN button.
2. Use the touch sensor to move to [RENAME].
3. Touch the RTN button.
*The model name setup screen is displayed.
4. Change the model name as described
below:
[Moving cursor in input box]
Select [←] or [→], and touch the RTN button.
[Deleting a character]
When [DELETE] is selected and the RTN button
is touched, the character immediately after
the cursor is deleted.
[Adding a character]
When a candidate character is selected
from the character list and the RTN button
is touched, that character is added at the
position immediately after the cursor.
*A name of up to 8 characters long can be entered as the
model name. (A space is also counted as 1 character.)
66 <Functions of Linkage Menu>
5. At the end of input, select [ENTER] and touch
the RTN button. (To terminate input and
return to the original state, select [CANCEL]
and touch the RTN button.)
Model copy
*A copy can be made of the current model.
1.Use the touch sensor to select the current
model in the model list and then touch the
RTN button.
2. Move to [COPY] with the touch sensor.
3. Touch the RTN button.
*The copy screen appears.
4. Use the touch sensor to move to the copy
destination position at the bottom of the
screen and touch the RTN button to switch to
the data input mode.
Select the save destination by turning the
touch sensor and touch the RTN button.
5. Use the touch sensor to move to [COPY].
6. Touch the RTN button. When a confirmation
message is displayed and the RTN button is
touched again, the model data is copied.
*FX-32 accepts a SD card formatted FAT file system, but
it does not supports the long file name feature used in
Windows or other modern operating systems. Thus FX-32
can accept files whose name consists of only 8 characters
or less. Furthermore, it supports only basic alphanumeric
characters such as 'A" to 'Z", '0' to '9' and '_'.