ROBBE-Futaba FX-32 Instruction Manual page 165

●Diplay mode selection
*When [rpm] mode is selected above setting, the display
mode can be selected.
* There is no change in the transmitter output even when the
"MODE" is changed. Calibration should be performed via
the governor.
* In order to use the Governor function of the FX-32, it is
necessary to change the settings on the governor for the low
side 700 rpm mode.
When the MODE of the Governor screen's
model menu is changed, the change is also
indicated on-screen.
The chart below indicates the
m o d e p e r c e n t a g e a n d t h e
corresponding RPM.
●Fine tuning VR settings
Move the cursor to the [--] item and touch
the RTN button to access the selection
screen. Select the control.
*For a description of the switch selection method, see the
description at the back of this manual.
Move the cursor to the rate item and touch
the RTN button to switch to the data input
mode.
Adjust the trim rate by scrolling the touch
sensor.
Initial value: 0% (0rpm)
Adjustment range: -20~+20% (-800~+800rpm)
*When the RTN button is touched for one second, the
sensitivity is reset to the initial value.)
Touch the RTN button to return to the cursor
mode.
<Functions of Model Menu (Helicopter Functions)> 165