ROBBE-Futaba FX-32 Instruction Manual page 120

3. After setting, switch to the cursor move mode
by touching the RTN button.
*At adjustment, the offset rate is reset to the initial value by
touching the RTN button for 1 second.
●Fine tuning trim setting
Operation control [CTRL], operation mode
[MODE], and rate [RATE] adjustment is possible
by [FINE TUNING] item.
(For a description of the fine tuning trim setting method, refer
to [Fine tuning trim setting] at the back of this manual.)
●Operation mode setting
The operation mode when the switch was
operated is selected. Normal mode [NORM] or
timer mode [TIME] can be selected.
[Normal mode]
After the switch is set to ON, mixing is turned
ON after the time set by start delay ([START]) has
elapsed. Similarly, after the switch was set to OFF,
mixing is turned OFF after the time set by stop
delay ([STOP]) has elapsed.
[Timer mode]
After the switch was set to ON, mixing is turned
ON after the time set by start delay ([START]) has
elapsed. Mixing is automatically turned OFF after
the time set by stop delay ([STOP]) has elapsed.
Examples of use are jet plane and scale model
retractable landing gear and cover linked mixing,
etc.
●Servo speed setting
The speed at function operation can be adjusted.
(For a description of the setting method, refer to
[Servo speed setting] at the back of the instruction
manual.)
●Delay setting
M i x i n g o p e r a t i o n a t m i x i n g s w i t c h O N
([START]) and OFF ([STOP]) can be delayed by
[DELAY] item.(When switch is set.)
1. Move the cursor to the [START] or [STOP]
item and switch to the date input mode by
touching the RTN button.
2. Turn the dial to the left and right and set the
mixing operation delay time at switch ON or
OFF.
Initial setting : 0sec
Setting range : 0sec~35sec
3. After adjustment, switch to the cursor move
mode by touching the RTN button.
*At adjustment, the delay time can be reset to the initial value
by touching the RTN button for 1 second.
120 <Model Menu (Common Functions)>