ROBBE-Futaba FX-32 Instruction Manual page 122

RUD to AIL
This mix is used to correct roll maneuvers,
knife edge, etc. of stunt planes. [Airplane/glider,
general]
CAMBER Mix
This mix adjusts the camber and corrects the
elevators. [Airplane/glider, 2 ailerons or more]
ELE to CAMBER
This mix is used when you want to the mix camber
flaps with elevator operation. Lifting force can
be increased at elevators up. [Airplane/glider, 2
ailerons or more]
CAMBERFLP to ELE
This mix is used to correct for attitude changes when
the camber flaps are being used. [Airplane/glider, 2
ailerons + 1 flap or more]
BUTTERFLY (Crow)
This function is used when powerful brake operation
is necessary. [Glider, 2 ailerons or more]
TRIM MIX 1/2
The ailerons, elevators, and flaps trim offset rate can
be called by switch or condition selection. [Glider, 2
ailerons or more]
AIRBRAKE
This function is used when airbrakes are necessary
when landing or when diving, etc. during flight.
(Airplane, general)
122 <Model Menu (Airplane/Glider Functions)>
GYRO
This is a dedicated mix when a GYA Series gyro is
used. [Airplane/glider, general]
V-TAIL
This function adjusts the elevators and rudder of
V-tail models. [Airplane/glider, V-tail specifications]
AILEVATOR
This function adjusts the elevators and ailerons of
models with elevator specifications. [Airplane/
glider, elevator specifications]
WINGLET
This function adjusts the left and right rudders
of winglet models. [Airplane/glider, winglet
specifications]
MOTOR
The operation speed when the motor of F5B and
other EP gliders is started by switch can be set. [EP
glider, general]
RUD to ELE
This function is used to correct roll maneuvers, knife
edge, etc. of stunt planes. [Airplane, general]
SNAP ROLL
This function selects the snap roll switch and adjusts
the steering angle of each rudder. Servo speed can
also be adjusted. [Airplane general]