ROBBE-Futaba FX-32 Instruction Manual page 109

*Use the touch sensor scrolling to move the cursor to the
"MODE" item of the channel you want to change and touch
the RTN button to switch to the data input mode and change
the mode by turning the touch sensor to the left or right. The
display blinks. Touch the RTN button to change the mode.
"NORM": The model is controlled by signals
from the student transmitter.
"MIX" mode: The model is controlled by
s i g n a l s f r o m t h e t e a c h e r a n d s t u d e n t
transmitters. (Reset the student's model data
to the default condition.)
"FUNC" mode (function mode):
The model is controlled by signals from
the student transmitter with the teacher
AFR setting. (Reset the student's model data
to the default condition.)
"OFF": Only the teacher side operates.
*The setting above allows setting of the servo throw relative
to the amount of student side operation when [MIX] or
[FUNC] was selected.
When changing the rate, use the touch
sensor scrolling to move the cursor to the
[RATE] item of the channel you want to
change and use the touch sensor to adjust
the rate.
Setting range: -100~+100
Initial value: +100
Touch the RTN button to end adjustment and
return to the cursor move mode.
*When the RTN button is touched for 1 second, the rate is
reset to the initial value.
3. Set the switch of each channel.
*When setting the switch at each channel, use the touch
sensor to move to the "SW" item of the channel you want
to change, call the switch setup screen by touching the RTN
button, and select the switch.
"--" : Always ON.
"SA"~"SH": The switch which enables student
side operation can be selected. (See "Switch
selection method" at the end of this manual
for selection method details.)
Trainer student channel setting function
Which channel of the signal from the student's
transmitter can be fetched as the instructor
functions input signal when "FUNC" or "MIX" was
set as the trainer function instructor's transmitter
mode setting can be set. This makes trainer
connection easy even when the instructor side and
student side channel assignment is different.
*When the instructor's transmitter mode is set to "NORM",
the signal of the same channel of the student's transmitter is
output as is.(The same as before.)
<Functions of Linkage Menu> 109