ROBBE-Futaba FX-32 Instruction Manual page 132

Setting method
● Move the cursor to the ACT/INH item and
touch the RTN button to switch to the data
input mode.
Turn the touch sensor to the left and touch
the RTN button. (ON is displayed.)
● When setting a switch, move the cursor to
the [--] item of the switch and touch the RTN
button to call the selection screen, and then
select the switch and set its ON direction.
(Always ON at "--" setting)
(For a description of the switch selection
method, see the description at the back of
this manual.)
● When setting a condition delay, move the
cursor to the [COND.DELAY] item and touch
the RTN button to switch to the data input
mode.
Set the delay with the touch sensor.
Touch the RTN button to end adjustment and
return to the cursol move mode.
When setting a cut switch, move the cursor
to [CUT-SW] item and touch the RTN button
to call the selection screen, and then select
132 <Model Menu (Airplane/Glider Functions)>
the switch and set its ON direction. (Always
ON at [--] setting)
(For a description of the condition delay
function, see the description at the back of
this manual.)
● Camber AFR(D/R) screen call
Move the cursor to the Camber AFR item
and touch the RTN button to call the setup
screen. (For a description of the setup
method, see the description at the back of
this manual.)
(Curve/rate setup screen)
● The curve and rate are adjusted by calling
the aileron, flap, and elevator curve/rate
screens.
The rate and curve of each servo can be set
by calling each screen. (For a description of
the curve setting method, see the description
at the back of this manual.)
The servo speed can also be adjusted.