ROBBE-Futaba FX-32 Instruction Manual page 170

Point curve (POINT) adjustment
Up to 11 or 17 points curve can be used.
(differs with functuion)
Initial point number: 9 points (17 points
curve), 11 points (11 points curve)
*The set points can be freely increased, decreased, and
offset.
[Rate adjustment of each point]
1. Use the touch sensor to move the cursor
(reverse-display) to the [POINT] or [RATE]
item and touch the RTN button to switch
to the curve setting mode.
*It is changed from the reverse-display to the square box
display.
*In this mode, touch the RTN button to switch the [POINT]
item and [RATE] item alternately.
2. Move the cursor (square box) to the
[POINT] item by touching the RTN button.
3. Turn the touch sensor to the left or right
and select the point whose rate you want
to set.
*The mark
point. The mark
deleted point.
4. Move the cursor (square box) to the [RATE]
item by touching the RTN button and set
the rate by turning the touch sensor to the
left or right.
Repeat steps 2 through 5 and adjust the
curve.
Push the S1 button to end adjustment and
return to the cursor move mode.
[Point addition]
1. In the curve setting mode, touch the RTN
button to move the cursor to the [POINT]
item and turn the touch sensor to the left
or right and move the cursor on the curve
to the position (mark ) you want to add.
2. When the RTN button is touched for 1
second, the point is added.
[Point deletion]
1. In the curve setting mode, touch the RTN
button to move the cursor to the [POINT]
item and turn the touch sensor to the
left or right and move the cursor on the
curve to the position (mark ) you want to
delete.
170 <Data>
(Point)
on the curve shows the currently selected
on the curve shows the currently
2. When the RTN button is touched for 1
second, the point is deleted.
[Offsetting the curve horizontally in the vertical
direction]
1. Use the touch sensor to move the cursor
(reverse-video) to the [OFFSET] item.
2. Move the curve in the vertical direction by
turning the touch sensor to the left or right.
Initial value: +0.0%
(When the RTN button is touched for 1 second, the curve is
reset to the initial value.)
Touch the RTN button to end adjustment
and return to the cursol move mode.