ROBBE-Futaba FX-32 Instruction Manual page 114

Condition name change
1. Use the touch sensor to move the cursor to
the condition you want to change in the
conditions list.
*The number before the condition name become reverse-
video to show that it is to be deleted.
2. Move the cursor to [RENAME] and touch the
RTN button.
*The condition name setup screen appears.
3. Change the condition name as described
below:
[Moving cursor in input box]
Select [←] or [→], and touch the RTN button.
[Deleting a character]
When [DELETE] is selected and the RTN button
is touched, the character immediately after
the cursor is deleted.
[Adding a character]
When a candidate character is selected
from the character list and the RTN button
is touched, that character is added at the
position immediately after the cursor.
*A name of up to 8 characters long can be entered as the
condition name. (A space is also counted as 1 character.)
5. At the end of input, select [ENTER] and touch
the RTN button. (To terminate input and
return to the original state, select [CANCEL]
and touch the RTN button.)
Condition copy
1. Use the touch sensor to move the cursor to
any condition in the conditions list and touch
the RTN button.
2. Use the touch sensor to move to [COPY].
3. Touch the RTN button.
*The copy screen appears.
4. Use the touch sensor to move the cursor to
the "SOURCE COND." (copy source) item and
touch the RTN button.
*The models already saved are displayed at the right side of
the screen.
5. After using the touch sensor to move the
cursor to the copy source condition, touch
the RTN button.
*The copy source condition is displayed at the "SOURCE
COND." position.
6. Use the touch sensor to move the cursor to
114 <Model Menu (Common Functions)>
"DESTIN.CND." (copy destination) and touch
the RTN button.
*The models already saved are displayed at the right side of
the screen.
7. After using the touch sensor to move the
cursor to the copy destination condition,
touch the RTN button.
*The copy destination conditions are displayed at the
"DESTIN.COND." position.
8. Use the touch sensor to move the cursor to
[COPY] and touch the RTN button.
9. When the RTN button is touched again, copy
is executed.(Operate touch sensor or S1
button to stop copying.)
Touch the RTN button to end adjustment and
return to the cursol move mode.
Priority change
1. Use the touch sensor to move the cursor to
the condition whose priority you want to
change in the condition list.
2. Move the cursor to [UP] or [DOWN] of
[PRIORITY] and touch the RTN button. (The
last condition becomes the highest priority.)
*The initial setting condition cannot be shifted. The priority
is the lowest.
Condition delay setting
1. Use the touch sensor to move the cursor to
the condition you want to change in the
condition list and touch the RTN button.
2. Move the cursor to [DELAY] and touch the
RTN button.
*The condition delay setup screen appears.
3. Use the touch sensor to move the cursor to
the "DELAY" item of the channel you want to
set and touch the RTN button to switch to the
data input mode.
Adjust the delay amount with the touch
sensor.
Initial value: 0
Adjustment range: 0~27 (maximum delay)
Touch the RTN button to end adjustment and
return to the cursol move mode.
● The setting mode (group [GROUP]/single
[SINGLE] mode) can be switched.
(For more information, see the description at the back of this
manual.)