ROBBE-Futaba FX-32 Instruction Manual page 108

● Select [TRAINER] at the system menu and call the
setup screen shown below by touching the RTN
button.
● Select the function name
and return to the Linkage
menu by touching the
RTN button or pushing the
Home/Exit button.
When using at the student side
1. Select the mode.
*When changing the mode, use the touch sensor to move
to the item you want to change and touch the RTN button
to switch to the data input mode and change the mode by
turning the touch sensor to the left or right. The display
blinks. Touch the RTN button to change the mode.
"TEACHER/STUDENT": Select [STUD] (student).
"ACT/INH": Enable operation by changing to
[ON].
"16/12/8 CH": When the student uses the FX-
32,T14SG, T18MZ, select [16CH]. When the
student uses the T14MZ, T12Z, T12FG or FX-40,
select [12CH]. Otherwise select [8CH].
Note: In "student mode", only the teacher
side can turn on and off the power to the
student's transmitter. Keep the power switch
always at off position.
108 <Functions of Linkage Menu>
<SensorTouch™>
When using at the teacher side
1. Select the mode.
*When changing the mode, use the touch sensor to move
to the item you want to change and touch the RTN button
to switch to the data input mode and change the mode by
turning the touch sensor to the left or right. The display
blinks. Touch the RTN button to change the mode.
"TEACHER/STUDENT": Select [TEACH].
"ACT/INH": Enable operation by changing to
[OFF] or [ON].
"16/12/8 CHANNEL": When the student uses
the FX-32 (including the T18MZ, T14SG)select
[16CH]. Otherwise select [12CH]or[8CH].
2. Select the trainer switch.
*When setting or changing the switch, use the touch sensor
to move to the "SWITCH" item, call the switch setup screen
by touching the RTN button and set the desired switch and
ON/OFF direction.
(See "Switch selection method" at the end of
this manual for selection method details.)
*The switch mode can also be selected when setting the
ON position on the switch setup screen. When [NORM] is
selected, normal ON/OFF operation is performed. When
[ALTERNATE] is selected, the trainer function is alternately
turned on and off each time the switch is operated. This
allows alternate ON/OFF switching even when a momentary
switch (SH) is used.
Note: The trainer function won't be turned
on unless the Instructor's transmitter receives
signals from the student's transmitter. Be
sure to confirm this after connecting your
trainer cable.
3. Select the operating mode for each channel.
Scrolling
● Moving cursor
● Selecting mode