ROBBE-Futaba FX-32 Instruction Manual page 23

DANGER
Don't touch wiring.
* There is a danger of receiving an electric shock.
Do not short-circuit the battery terminals.
* A short circuit across the battery terminals may cause
abnormal heating, fire and burns.
Please double check your polarity ( ＋ and
－ ) when hooking up your connectors.
* If ＋ and － of wiring are mistaken, it will damage,
ignite and explode.
Don't connection to Extra Voltage before
turning on a receiver power supply.
R7008SB CH Mode
The R7008SB receiver is a very versatile
unit. It has 8 PWM outputs, S.BUS and S.BUS2
outputs. Additionally the PWM outputs can be
changed from channels 1-8 to channels 9-16. If
you only desire to use it as an 8 channel receiver
(without S.BUS), it can be used without any
setting changes.
The FX-32 has the ability to link to two
R7008SB receivers. One of them outputting
channels 1-8 and the other outputting channels
9-16 giving you 16 PWM channels. Instructions
for this configuration and S.BUS operation
follow.
R e c e i v e r
connector
1
2
3
4
5
6
7/B
8/SB
Red LED blink
R7008SB CH MODE TABLE
Setting channel
Mode A Mode B
1～8CH 1～7CH
1 1
2 2
3 3
4 4
5 5
6 6
7 7
8 S.BUS
1time 2time
[How to change the R7008SB Channel mode.]
1. Press and hold down the Link/Mode button on
the R7008SB receiver.
2. Turn the receiver on while holding down the
Link/Mode button. when the LED begins to
blink green/red the button may be released.
3. The LED should now be blinking red in one of
the patterns described by the chart below.
4. Each press of the Mode/Link button advances
the receiver to the next mode.
5. When you reach the mode that you wish to
operate in, press and hold the Mode/Link
button for more than 2 seconds.
6. Once locked into the correct mode the LED will
change to a solid color.
7. Please cycle the receiver(s) power off and back
on again after changing the Channel Mode.
Mode C
9～16CH
9
10
11
12
13
14
15
16
3time
Mode D
9 15CH
9
10
11
12
13
14
15
S.BUS
4time
<Before Use>
23