ROBBE-Futaba FX-32 Instruction Manual page 52

5. Idle down setting
The idling speed can be lowered with one touch
by a switch without changing the throttle trim
position. Perform this setting with the Idle Down
function of the Linkage Menu. After activating the
Idle Down function and selecting the switch, adjust
the idle down speed. For safety, the idle down
function acts only when the throttle stick is slow
side.
*While the Throttle Cut function is in operation, the Idle
Down function does not work.
6. AFR (D/R)
AFR function is used to adjust the throw and
operation curve of the stick, lever, and switch
functions for each flight condition. This is
normally used after End Point has defined the
maximum throw directions.
7. Airbrake
This function is used when an air brake is
necessary when taking off or diving, etc.
The preset elevators and flaps (camber flap,
brake flap) offset amount can be activated by a
switch.
The offset amount of the aileron, elevator, and
flap servos can be adjusted as needed. Also the
speed of the aileron, elevator, and flap servos can
be adjusted. (IN side/OUT side) A delay can be set
for each condition, and a Cut switch which will
turn OFF the delay can be chosen. Trim amounts
52 <Model Basic Setting Procedure>
can be fine-tuned by setting a VR. You can also set
the Auto Mode, which will link Airbrake to a stick,
switch, or dial. A separate stick switch or dial can
also be set as the ON/OFF switch.
8. Addition of flight conditions
The Condition Select function automatically
allocates the Condition 1 (CONDIT1) for each
model. Condition 1 is the default condition and
is the only one active when a new model type is
defined.
If you want to add flight conditions, please refer
to a description of the COND. SELECT function.
*The Condition 1 is always on, and remains on until other
conditions are activated by switches.
*When a new condition is added, the model data of the
Condition 1 is automatically copied to the new condition.
*You can set the model data of new condition in the switch
ON state. However, if the group mode (GROUP) was
selected in advance, the same data will be input at all the
conditions. Select the single mode (SINGLE) and adjust
only the condition you want to change. For Group/Single
mode switching, refer to the description at the back of this
manual.
*The Condition Delay can be programmed for each channel.
The Condition Delay is used to change the servo throw
smoothly when switching conditions.
9. When tailless wing model selected
Tailless wing elevator operation uses elevator to
camber mixing. This function cannot be performed
at initial setting.