ROBBE-Futaba FX-32 Instruction Manual page 171

Switch selection method
The various functions used in the FX-32 can be selected by switch. The switch (including when stick,
trim lever, or VR are used as a switch) setting method is common to all functions.
Switch selection
When a switch is selected at a mixing function, etc., the selection screen shown below is called.
Switch selection
1. Use the touch sensor to move the cursor
(highlights) to the switch you want to
select and touch the RTN button.
*The switch blinks.
2. To return to the preceeding screen, move
the cursor to the [HARDWARE SEL.] at
the top of the screen and touch the RTN
button.
Or, move the cursor to the [ON/OFF] and
call the ON/OFF position setting screen by
touching the RTN button.
When switch was selected
When switch was selected, ON/OFF position
setting is also performed.
*The ON/OFF setting state of each position is displayed.
1. When you want to change the ON/OFF
setting, use the touch sensor to move the
cursor and touch the RTN button to switch
to the data input mode. Switch the ON/
Off display by turning the touch sensor to
the left or right.
*ON/OFF display blinks.
3. When the EDIT button is pressed, the ON/
OFF setting is changed. (Operate the
touch sensor or S1 button to stop the
change.)
4. To return to the preceeding screen, move
the cursor to the [ON/OFF] at the top of
the screen and touch the RTN button.
(Switch selection screen example)
When stick, trim lever, or knob selected
When a stick, trim lever, or knob is used as a
switch, four operation modes can be selected by
the following mode and type combination:
1. When you want to change the mode,
move the cursor to [MODE] and touch
the RTN button to switch to the data input
mode. Switch the display to the mode
you want to change by turning the touch
sensor to the left or right and then make
the change by touching the RTN button.
●Mode: [LINEAR]/[SYMMETRY]
*Set the ON/Off point by the method described on the next page.
Alternate mode setting
●Mode: [NORMAL]/[ALTERNATE]
1. Move the cursor to the [ALTERNATE] item
and touch the RTN button to switch to the
data input mode.
2. Change to the mode you want to set by
turning the touch sensor to the left or right.
*The mode display blinks.
3. Touch the RTN button. (Operate the touch
sensor or S1 button to stop the change.)
4. To return to the preceeding screen, move
the cursor to the [ON/OFF] at the top of the
screen and touch the RTN button.
<Data> 171