ROBBE-Futaba FX-32 Instruction Manual page 118

●Master CH
●Slave CH
●ON/OFF
*Perform the settings below after using the touch sensor to
move the cursor to the item you want to set.
●Group/single mode selection
1. When you want to activate functions for only
selected conditions, move the cursor to the
[GROUP] item and touch the RTN button to
switch to the data input mode.
2. Turn the touch sensor to the left until [SINGLE]
starts to blink and then touch the RTN button.
*The mode changes to the single mode [SINGLE].
*When using common settings at each conditions, remain in
the [GROUP] mode.
●Activate the function.
1. Move the cursor to [INH] and touch the RTN
button to switch to the data input mode.
2. Turn the touch sensor to the left until [ACT]
starts to blink and then touch the RTN button.
*The function is activated. (ON or OFF display)
*ON/OFF switch and mix rate are not set even through the
function is activated.
●ON/OFF switch setting
Move the cursor to the [SWITCH] item, call
the switch setup screen by touching the
RTN button, and select the switch and ON
direction.
118 <Model Menu (Common Functions)>
●Fine tuning trim setting
(For a description of the setting method, see the description
at the back of this manual.)
●Switch selection
(For a description of the switch setting method, see the
description at the back of this manual.)
●Link setting
●Servo speed setting
(For a description of the setting
method, see the description at
the back of this manual.)
●Mix ON/OFF delay
(For a description of the setting method, see [Switch Setting
Method] at the back of this manual.)
*Always on when [--].
●Master channel setting
1. Move the cursor to the [FUNCTION.H/W] item
of [MASTER] and touch the RTN button to
switch to the data input mode.
Select the function by scrolling the touch
sensor and touch the RTN button.
2. When you want to link this mixing with other
mixes, move the cursor to the [LINK] item and
touch the RTN button to switch to the data
input mode.
Set the link mode to [+] or [-] by scrolling the
touch sensor and touch the RTN button.
*Check the direction by actual operation.
*Master channel control can be set to simple operating
amount of sticks and VR which do not include ATV, AFR,
D/R, and mixing setting. In this case, the switch setup
screen is displayed by touching the RTN button with "H/W"
selected by function selection. Select master channel side
control. (To terminate the "H/W" selection, select the [--]
display and touch the RTN button.
●Slave channel setting
1. Move the cursor to the [FUNCTION.H/W]
item of [SLAVE] and touch the RTN button to
●Trim mode setting
●Slave CH AFR mode