ROBBE-Futaba FX-32 Instruction Manual page 156

Throttle Limiter
This function limits throttle operation to within a
certain range. Control which adjusts the operating
range during flight can be set. (Effective only when
the model type is helicopter.)
*When the limiter operation range adjustment control is
NULL, the throttle limiter function is not activated.
● Open the THR CURVE setup screen.
Push S1 button to advance to next
page and display page4.
● Throttle limiter activation
position
Setting method
● Activate the function
1. Select "ACT/INH" and touch the RTN button.
2. Scrolling the touch sensor and switch the
display to [INH] or [ACT].
3. Touch the RTN button.
● Group/single mode selection.
1. Select "GROUP" and touch the RTN button.
2. Scrolling the touch sensor and switch the
display to [GROUP] or [SINGLE].
3. Touch the RTN button.
● ON/OFF switch setting
1. Select "SWITCH" and touch the RTN button.
2. A hardware selection screen is displayed.
Select the hardware and touch the RTN
button.
● Hight side operation range setting
1. Select "HIGH" and touch the RTN button.
2. Scrolling the touch sensor and adjust the high
156 <Functions of Model Menu (Helicopter Functions)>
● Throttle limiter function
ACT/INH
● High side operation range
● Low side operation range
The high side of a
throttle can restrict
to this range by
CONTROL.
● Condition group/single
● Mixing ON/OFF switch
● Limiter activation position
adjustment control
● The limit value at the operation hardware neutral
position can be adjusted using the throttle limiter.
T h e n e u t r a l p o s i t i o n o f
CONTROL
● When CENTER is INH.
The motion with the
equal upper and lower
sides is carried out.
side operation range.
3. Touch the RTN button.
● Low side operation range setting
1. Select "LOW" and touch the RTN button.
2. Scrolling the touch sensor and adjust the low
side operation range.
3. Touch the RTN button.
● The neutral position of "CONTROL" setting
1. Select "CENTER" and touch the RTN button.
2. Scrolling the touch sensor and adjust the
neutral position.
3. Touch the RTN button.
● Limiter activation position adjustment control
setting
1. Select "CONTROL" and touch the RTN button.
2. A hardware selection screen is displayed.
Select the hardware and touch the RTN
button.
T h e n e u t r a l p o s i t i o n o f
CONTROL
● When CENTER is 28%.
The amount of operations
above CONTROL
increases.