Airbrake To Ele - ROBBE-Futaba FX-32 Instruction Manual

AIRBRAKE to ELE

This mix is used when you want to mix the
elevators with airbrake (spoiler) operation. It
raises the elevators to correct for dropping of the
nose during airbrake operation.
*This function does not operate when airbrake is not assigned
at the Function menu in the Linkage Menu.
● The Rate 1 side/Rate 2 side mixing rate with the
elevator servos can be adjusted.
● A mixing curve can be set.
● Mixing during flight can be turned ON/OFF by
setting a switch. (Always ON at [--] setting)
● The mixing rate can be fine-tuned by setting a VR.
● Select [AIRBRAKE to ELE] at the model
menu and call the setup screen shown
below by touching the RTN button.
● S e l e c t t h e f u n c t i o n
name and return to the
p r e c e d i n g s c r e e n b y
touching the RTN button
or pushing the Home/Exit
button.
● Group/single mode
switching
(For more information,
refer to the description at
the back of this manual.)
● Adjustment of
each elevator
servo
128 <Model Menu (Airplane/Glider Functions)>
[Corresponding model type]: Airplane/glider, general
● Mixing curve setting
*For a description of the curve setting method, see the
description at the back of this manual.
*The display screen is an example. The actual
screen depends on the model type.
(Currently selected condition name)
<SensorTouch™>
● Overall adjustment by
Rate A and Rate B.
● Fine tuning VR setting
● Operation mode
● Adjustment rate
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To next page