Alarm Configuration; Events Configuration - Black Box 12-Port 1000BASE-TX L2 Managed PoE Switch User Manual

Parameter
max. Request (1-10)
suppTimeout (1-65535 s)
serverTimeout (1-65535 s)

4.18 Alarm Configuration

4.18.1 E C
VENTS ONFIGURATION
The Trap Events Configuration function is used to enable the switch to send out the trap information while
pre-defined trap events occurred. The switch offers 22 different trap events to users for switch management. The
trap information can be sent out in three ways, including email, mobile phone SMS (short message system) and
trap. The message will be sent while users tick ( ) the trap event individually on the web page shown as below.
Parameter
Trap
STP
LACP
GVRP
VLAN
Module Swap
PoE
Table 4-47 (continued). Parameter Setting screen options.
The maximum of number times that the authenticator will retransmit
an EAP Request to the supplicant before it times out the
authentication session. The valid range: 1 – 10.
Default: 2 times
A timeout condition in the exchange between the authenticator and
the supplicant. The valid range: 1 –65535.
Default: 30 seconds
A timeout condition in the exchange between the authenticator and
the authentication server. The valid range: 1 –65535.
Default: 30 seconds
Table 4-48. Events Configuration screen options.
Cold Start, Warm Start, Link Down, Link Up, Authentication
Failure, User login, User logout
STP Topology Changed, STP Disabled, STP Enabled
LACP Disabled, LACP Enabled, LACP Member Added, LACP Port
Failure
GVRP Disabled, GVRP Enabled
Port-based VLAN Enabled, Tag-based VLAN Enabled
Module Inserted, Module Removed, Dual Media Swapped
PoE Failure
CHAPTER 4: Web-Based Management
Description
Description
83