Black Box 12-Port 1000BASE-TX L2 Managed PoE Switch User Manual page 26

Set IP Address, Subnet Mask, and Default Gateway IP Address
The switch's default IP address, gateway, and subnet mask are listed in Table 3-2.
Table 3-2. The switch's default and revised network settings.
Parameter
IP Address
Subnet
Default Gateway
There are no default DNS settings. DNS addresses are assigned by the network
administrator.
You can first either configure your PC's IP address or change the switch's IP address, then change the default
gateway's IP address and subnet mask.
For example, suppose your network address is 10.1.1.0, and the subnet mask is 255.255.255.0. You can change
the switch's default IP address 192.168.1.1 to 10.1.1.1 and set the subnet mask to 255.255.255.0. Then, choose
the default gateway's address (for example 10.1.1.254).
After completing these settings, reboot it so the configuration takes effect. After this step, operate the
management through the network, either from a Web browser or Network Management System (NMS). See
Figure 3-8.
Copyright (c) 1981–2005 Black Box Corp.
L2 Managed Switch
Login: admin
Password:
LPB200A#
Default Value
192.168.1.1
255.255.255.0
192.168.1.254
LPB200A
Figure 3-8. The CLI login screen for the LPB200A.
CHAPTER 3: Installation
Sample Network Setting
10.1.1.1
255.255.255.0
10.1.1.254
NOTE
23